One - Step Solution
Multi - Purpose Solution
For daily cleaning, disinfecting, rinsing and storing
of all soft and hard contact lenses
Contents
SeptoCare Plus One Step Solution is a sterile, isotonic and buffered solution containing Sodium Chloride USP, Poloxamer 407NF, Propylene Glycol USP, preserved with Dichlorophenyl Tetraguanidohexane BP 0.0025%, edetate disodium USP 0.01% and buffered with phosphates NF. Contains No Thimerosal.
Precautions
Do not mix with other fluids except as directed
Do not use concurrently with any eye medicament except on medical advice
Not intended for use directly in the eye
If eye irritation occurs or persists, discontinue use, remove lenses and consult your eye care practitioner
Do not use with any heat disinfecting method
Store at room temperature ( 15° - 30° C ). Do not freeze
Protect from direct sunlight
Keep out of reach of children
This bottle is completely sealed for your protection
To open
SeptoCare Safety Ring
1. Unscrew the cap and discard
the safety ring
2. After removing the safety ring,
screw in the cap tightly until
the cone pin punctures the
bottle tip and breaks the seal.
The cone pin will also reseal
the opened bottle
Contact Lens Solutions
T M
T M
T M
T M
T M
T M
Directions
Before handling contact lenses, wash and dry hands
thoroughly. Remove right lens from the eye and clean by
applying a few drops of SeptoCare Plus One - Step
Solution to the lens. Rub the lens gently for approximately
20 seconds either on the palm using the forefinger of the
other hand or between the thumb and forefinger.
Rinse the lens with SeptoCare Plus One - Step Solution
to remove debris. Place lens in appropriate compartment
of the lens case and fill with SeptoCare Plus One - Step
Solution. Repeat the procedure with the left lens. Secure
the cap. To assure proper disinfection, store the lenses in
SeptoCare Plus One - Step Solution for a minimum of 4
hours or overnight.
Prior to insertion, it is recommended to rinse lens thoroughly.
SeptoCare Plus One - Step Solution maybe used to rinse
the storage case.
Discard unused solution 90 days after opening.
Important
For a maximum comfort, it is important to remove protein
deposits from lenses once a week with protein remover.
After protein removal, lenses must be cleaned and
disinfected before wearing
Manufactured in accordance with the
Australian Code of Good Manufacturing Practice
Copyright (c) 2000-2002 I.O.S. Marketing
Corporation. Developed by Simplick Automation Systems. All rights reserved.
ios@info.com.ph